top of page

TX1000 V3 FM Transmitter

Now with a DDS exciter, the TX1000 V3 takes the legendary and clean exciters

of earlier models with it's ultra-low distortion modulator to a new level.

The TX1000 V3 has an integrated multi-band DSPX audio processor that

meansstations without a dedicated processor sound great, right out of the

box. This market leading DSP based multi-channel audio processor has been

designed to give you a major market signature sound on a budget. With both

four band program dependent limiting and wide band AGC with intelligent

gating, parametric EQ and shelf bass enhancement, multi band distortion

controlled clipper and a powerful composite clipper with pilot protection. All this allows you to tailor your sound for maximum impact.

For years, our transmitters have been the most intelligent on the market with standard Ethernet Remote Control. Featuring a built-in web browser, with no software to install and no reliance on flash support, the V3 platform gives you easy access to setup and monitoring such as Email Alerts, SNMP monitoring, Silence Detection, Advanced Alarms. The unit will email you if it has a problem, and keep a log of any issues to be investigated. You can also adjust settings remotely if required. All these features are designed to give you peace of mind and save you time.

A standard, configurable parallel GPI/O interface is provided for interfacing to your station remote control equipment. This will alert you to issues and offer solutions to keep you on air. For example, it can be configured to switch on back-up audio or back-up transmitters should it detect a problem.

All V3 products have inputs and outputs you would come to expect of with a premium Transmitter. Featuring AES3 audio or composite/ MPX over AES192, analog left and right, and 2 configurable composite (MPX) program inputs and outputs. Composite inputs and outputs can be configured as MPX, SCA, RDS or Pilot Sync.

FSK ID Keyer as standard for translators removes the need for external hardware or hourly audible announcements and offers broadcasters a one-box solution for their translator sites.

Integrated Static RDS is now standard on-board.

External reference support for both 1pps and 10MHz GPS sync inputs are at the rear of the unit, letting you integrate with other products for an SFN (single frequency network) environment.

Hot-pluggable, simple to replace switch-mode power supplies with 96% efficiency. Combining rocksolid reliability, performance and simple maintenance to keep you on the air.


The new V3 Transmitter range now comes with the latest Direct to Channel Digital Modulation. This 1000W, 2U FM transmitter is the perfect piece of equipment for you. Built in 4-band DSP audio processing, Ethernet control, RDS Encoder and FSK IDer, GPS inputs for SFN applications, Hot swap PSU and a whole lot more.

In Detail
bottom of page